This script embosses PEF 2008-1 documents.
To achieve correct result using Braillo embossers, the embosser must be configured for "USA 6 DOT 001.00" or "ENGLAND 6 DOT 044.00".
To achieve correct result using other embossers with the script "Emboss PEF (generic embosser)", the embosser must be configured for North American ASCII Braille and dual-sided embossing.
Note that, when using "Emboss PEF (generic embosser)" some features will not be available. These are marked with * below.
The Portable Embosser Format (PEF) is a data format for representing braille books, accurately and unambiguously. PEF can be used for braille embossing and archiving anywhere in the world, no matter where nor how it was produced. PEF is a digital braille hardcopy - the PDF of braille books, if you will.
For more information, see Introduction to PEF.
The scripts assumes that the Marburg Medium spacing measurments can be used when calculating space reqirements etc. In other words, to achieve correct result, braille cells must be 6 mm wide and lines must be 10 mm high once embossed.
This script does not support files containing braille patterns specific for 8 dot braille.
I get an error message saying "Cannot fit page on paper"...
I get an error message saying "Cannot fit page on paper with offset [x]"...
I get an error message saying "Could not find embosser". What should I do?
Check the device name parameter for typos. Note that the device name is case sensitive.
I don't know what "device name" is. How do I find it?
On windows, do the following:
I have a Braillo embosser and everything comes out wrong...
My document contains more than 100 pages but my Braillo 440 embosser cannot handle that amount of pages in one go. What should I do?
If the document has been organized into volumes, there is nothing to worry about since each volume will be sent separately to the embosser. If a single volume happens to contain more than 99 pages, the script will report an error and abort.
This script accepts PEF 2008-1 documents (containing 6 dot braille patterns only).
The output is an embossed document.
Each volume in the input document will result in a separate physical unit if embossed using an embosser that supports volume assembly (e.g. Braillo 440SW and Braillo 440SWSF).
If the paper is wider than specified in the file, it is possible to adjust the margin offset (in characters). Offset depends on paper width error handling and is directed away from the alignment edge.
Note that this setting only has effect if the selected paper is wider than specified in the file.
Applies to double sided material when the paper is wider than specified in the file. If true, left-hand pages will have the opposite alignment compared to right-hand pages. If false, left-hand pages will have the same alignment as right-hand pages.
Note that this setting only has effect if the selected paper is wider than specified in the file.
The documents linked below are parts of the Transformer technical documentation. These are developer and systems-administrator centric documents.